Recent Examples on the WebClamp a stop block to the miter gauge fence, and butt the workpiece to it [5]. Rosario Capotosto, Popular Mechanics, 28 Aug. 2021 Use a tenoning jig to hold the workpiece vertically. Rosario Capotosto, Popular Mechanics, 28 Aug. 2021 The nomenclature is tricky in this respect: A similar cut made along the length of the workpiece, such as in the edge or face of the board, is known simply as a groove, not a dado. Roy Berendsohn, Popular Mechanics, 24 Feb. 2021 Some are hollow, so a drill or boring attachment can be fed through the tailstock and into the end of the workpiece while it’s still fully supported. Bob Beacham, chicagotribune.com, 26 Feb. 2021 Dowels have a tendency to rotate slightly when cut with a miter saw, which can lead to uneven or scorched cuts, so use a cradle that securely holds the workpiece. David Agrell, Popular Mechanics, 12 Dec. 2020 The workpiece wouldn't be sufficiently supported by the saw's fence, and the blade could easily grab the piece and pull my hand into its path. Paul Steiner, Popular Mechanics, 19 Sep. 2020 Drive a couple of screws through each arm and into the back support, taking care not to blow out through the workpiece. David Agrell, Popular Mechanics, 1 Feb. 2020 When the torch is held close to the workpiece an electric arc forms between its surface and the wire.The Economist, 14 Nov. 2019 See More